Daewoo DSA-100L Bedienungsanleitung PDF herunterladen (Seite 8)

page 8

The distances between the gate pivot point and the drive operator pivot point are determined by the spindle

stroke of 300 mm, which can be used fully or only partially to achieve a wing opening angle of 90°.

With an opening angle of 90°, the following reference values apply:

Spindle lift = a + b, whereby a and b should be chosen more or less equal.

In the case of larger gate wings, the full working stroke should be used in order to limit the gate speed of the

wing outer edges. For smaller gate wings, the opening time can be reduced by decreasing the values a and

For Hörmann aluminium hinged gate systems the values listed in table 2 are applicable for the dimensions in

fig. 3g. To make it easier to determine the fixing point, the X, Y, Z hole size co-ordinates, separate for left-

and right-hand hinging, can be taken from fig. 3f. It is important to observe the specified dimensions. Insert

the hinged gate drive operator into the corresponding drill hole of the post mounting bracket and screw in

place with hexagon nut M 10. If the spindle is retracted, connect the front hinge of the drive operator, fig. 1,

point C, to the mounting bracket on the gate wing, and with the gate in the "open" position, fix this to the gate

wing.

Determining the pivot points

Table 2

Wing width a b LH- RH- c dmax. Opening time

mm mm mm hinging hinging mm in sec. at 90°

1000 - 2000 88 107 Z1 X1 * 765 19

2000 - 2500 108 107 Z2 X2 * 765 21

2500 - 3000 108 127 Y2 Y2 * 765 23

* Distance "c" with LH-hinging (drive operator on left gate wing, as illustrated): hole 1

* Distance "c" with RH-hinging (drive operator on right gate wing): hole 2

c *

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 29 30

Keine Kommentare

Daewoo DSA-100L Bedienungsanleitung Seite 8