Daewoo ST Series Betriebsanleitung PDF herunterladen (Seite 18)

3.1.8. Engine Stop & Warning Devices

L136/T/TI/086TI gauge panel is equipped with warning lamps and an audible alarm to alert the

operator as follows.

1) Engine Stop Device (Stop solenoid)

Engine stop solenoid is operated with warning lamps and buzzer sound at the same time as

follows.

•

When the engine oil pressure is less than 0.5 kg/cm

•

When the engine water temperature is more than 100 °C.(212 °F)

2) Engine Warning Lamps

Engine warning lamp is turned on with buzzer sound at the same time as follows.

•

When the engine oil pressure is less than 0.5 kg/cm

•

When the engine water temperature is more than 100 °C.

•

When the battery is not charged.

The alarm horn will sound when the ignition is turned on and continue to sound until the key

switch is shifted into “OFF” position or minimum oil pressure is obtained. This provides a

functional test of warning system.

Should engine coolant overheat occurs, the alarm horn will sound and the engine is stopped

by stop solenoid at the same time automatically. Proceed as follows:

•

First, quickly observe the water temperature gauge for engine coolant overheat and / or

needle oscillation indicating low coolant.

•

If the temperature gauge indicates engine coolant overheat range, put the control lever back

to the idle speed position IMMEDIATELY and shift the reduction gear control lever into the

NETURAL position. Do not restart engine until the cause for the alarm has been found and

corrected. Refer to “Overheating” in “8. Trouble Shooting” Chart.

•

If the temperature gauge indicates high coolant temperature, check lack of coolant to fill

expansion tank or thermal sensor malfunction.

•

If the cause for the alarm cannot be found, contact your DAEWOO dealer.

- 15 -

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 182 183

Keine Kommentare

Daewoo ST Series Betriebsanleitung Seite 18