Daewoo ST Series Betriebsanleitung PDF herunterladen (Seite 19)

3.2. Starting

3.2.1. Operation 1

After checking the warning lamps of the gauge panel and the NEUTRAL position of reduction

gear control lever, turn the key switch to the START position to crank the engine, at once.

Behavior - When the key switch is placed in the START position.

3.2.2. Operation 2

After the engine is cranked, convert the key switch to the ACC position quickly.

Behavior - As the engine is cranked, don’t fix the key switch too long (over 5 seconds) in the

START position. If you do so, the starter may be malfunction.

If you fail the engine starting at first, restart the engine after waiting for 30 seconds at least to

prevent the circuit malfunction of the starter.

3.3. Engine Break-in

All DAEWOO marine engines have been run for a short period of time as a final test at the

factory. During the first 20 hours of operation, you must follow the Engine Break-In procedure

to ensure maximum performance and long engine life.

Note : Failure to follow the Engine Break-in procedure may result in serious engine

damage and will avoid the engine warranty.

During the break-in period, be particularly observe as follows :

•

Check engine oil level frequently. Maintain oil level in the safe range, between the “min.” and

“max.” marks on dipstick.

•

Watch the oil pressure warning lamp. If the lamp blinks whenever the boat attitude (i.e.

turning, climbing on plane, etc.) is changed, it may be the oil pick-up screen not to be

covered with oil. Check oil dipstick and if required, add oil to the oil pan. But do not fill over

maximum level.

Note : Oil pressure will rise as RPM increases, and fall as the engine RPM decreases. In

addition, cold oil will generally show higher oil pressure for any specific RPM than hot

oil. Both of these conditions reflect normal engine operation.

•

Watch the engine water temperature gauge and be sure there is proper water circulation. The

water temperature gauge needle may fluctuate if water level in expansion tank is too low.

- 16 -

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 182 183

Keine Kommentare

Daewoo ST Series Betriebsanleitung Seite 19