Daewoo ST Series Betriebsanleitung Seite 26

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 183
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 25
4.3. Cooling System
4.3.1. Coolant level check and refill
Replenish the deficient coolant in the expansion tank every day before running. The coolant
must be changed at intervals of 1,200 hours operation or six months whichever comes first.
If the coolant is being fouled greatly, it will lead engine overheat or coolant blow off from the
expansion tank.
Clean fresh water should be used for engine coolant.
Additional agent (35 ~ 40% anti-freeze and 3 ~ 5% anti-corrosion agent) should be mixed
with fresh water for engine coolant to prevent the cooling system problem like freezing,
corrosion and etc.
CAUTION : Suitable mixture of anti-freeze and anti-corrosion agent can protect the engine
corrosion from deteriorating and raises a boiling point, but by using unsuitable
mixture engine components like water pump impeller and water jacket of cylinder
block may be occurred a malfunction by any bad corrosion damage or cavitation.
(1) Coolant replenishment
Let the plug in the highest level of the water lines or the upper plug of wet turbocharger
open, and fill the coolant about three forth of the expansion tank slowly until the air bubbles
in water do not come out through the plug hole. Then reassemble the plug.
After filling the coolant, run the engine at the idle rpm for around 5 minutes and you will
find out the engine coolant level becomes lower than before cause of escaping the air
bubbles in water. Then stop the engine and replenish additional coolant properly.
(2) Coolant change
Open the pressure cap of
expansion to remove the air
pressure.
Loosen two drain plugs. One is
lower side of the oil cooler and
another is upper side of the
starter as figure.
After drain reassemble the plug
and replenish the coolant as same
as “(1) Coolant replenishment”.
CAUTION : When remove the pressure of the filler cap while the engine is still hot, cover the
cap with a cloth, then turn it left slowly to release internal steam pressure. This
will prevent a person from scalding by hot steam spouted out from the filler cap.
- 23 -
EC5OM127
Drain plug
Seitenansicht 25
1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 182 183

Kommentare zu diesen Handbüchern

Keine Kommentare